Revamping sand preparation plant

The entire sand preparation plant of Daimler in Mannheim will be renewed in two steps. The first phase took place during the summer-standstill 2016. Customers production could start at 22.08.2016 in time. It was a compete electrical retrofit of the prepared sand plant ( operating the moulding lines no. 2 and 4 ) as well as the associated four mixers.…

Punctual start of production after revamp of cupola furnace

Low voltage equipment as well as automation system of cupola furnace including ancillary plants ( charging, heating system, ferro alloy, water treatment ) were fully renewed at Duktus foundry in Wetzlar. Furthermore new cable routes had to be designed and built to replace the wiring of all field devices. The main retrofit was made within a two week summer-standstill after…

Successful start up of gate system

The entries and exits of the new DHL parcel center in Obertshausen were equipped with a new automation system. This was done by implementing¬† dynamic detection systems for the truck swapbodies. The drivers will be informed about the target place and the gates were automatically controlled after check of plausibility with the in-house logistic software. Evaluation of situation, engineering, erection…